Release of a
three phases timer
Marc 14 2016
You who want an industrial three phases relay
timer controlled,
Then you need that unit !
The MinuTri is a set
of 2 units involved in three-phases load control. These 2 units are connected
with a cable.
The 2 units of the
MinuTri set are:
MinuTri-C:
|
This first unit
is the command unit of the set. |
|
This unit is the
user interface. |
|
The MinuTri-C
includes:
|
A large led
display allowing a timer up to 59 minutes and 59 seconds. |
|
Five buttons
(+, -, OK, ESC and Start/Restart/Stop) for operation. |
|
The link with
the MinuTri-P. |
|
|
One action on the
Start/Restart/Stop button activates the relay and starts the count down. |
|
In operation, the
display indicates the time left. |
|
During the last
minute, the tens of minutes and the minutes are blinking. |
|
25s before end of
time, increased loud bips are generated. |
|
A press of less
than 2 seconds on the Start/Restart/Stop button restarts the timer to the
preprogrammed value. |
|
When the timer
reaches zero, the relay releases, the preprogrammed time is displayed and
the points in between the display characters are blinking one after the
other. |
|
After 2 minutes
of points blinking, the MinuTri-C enters in power saving mode: the display
becomes off and only one point blinks. |
|
A more than 3
seconds simultaneous press on the OK, + and – buttons allows to adjust the
programmed time. |
|
A
more than 3 seconds simultaneous press on the ESC, + and – buttons allows to
adjust the bips loudness. |
|
Detailed indications on the case allow the user to make the necessary
adjustments without user manual. |